replacement of sand by fly ash and bottom ash

Investigation on Leaching Behaviour of Fly Ash and Bottom ...

In this study, the potential heavy metals leached out from SCC that is produced with fly ash as a replacement for Ordinary Portland Cement and bottom ash as a substitute for sand with the ratios from 10% to 30% respectively were designated and cast.

BOTTOM ASH AS AGGREGATE REPLACEMENT IN …

Another potential application of bottom ash is for internal curing of high-volume fly ash (HVFA) concrete – concrete with at least 50% of the Portland cement replaced with fly ash. Traditional specifications limit the amount of fly ash to 35 or 40% cement replacement.

Sustainable Construction with Coal Combustion Products

Bottom ash is a heavier, granular material that is collected from the bottom of coal-fueled boilers. Bottom ash is often used as an aggregate to replace sand and gravel, and as an ingredient in masonry products including concrete blocks.

Uses of Bottom ash in the Replacement of fine aggregate ...

Uses of Bottom ash in the Replacement of fine aggregate for Making Concrete ... surface texture predominantly sand-sized. This material is composed of silica, alumina, and iron with small amounts ... Non-availability of dry fly ash and bottom ash. Lack of proper co-ordination.

USE OF BOTTOM ASH IN LIEU OF SAND AS FILTER IN ASH …

Grain Size: Bottom ash and pond ash are coarser than fly ash. Bottom ash has size in the range of sand size. Case History: Plan and Cross-section of Ash Pond at the Thermal Power ... Hence, bottom ash was allowed to replace the sand in the internal drainage with thickness of 1000mm instead of 750mm for sand.

Bottom Ash as Partial Sand Replacement in Concrete- A ...

Bottom Ash as Partial Sand Replacement in Concrete- A Review The study of K. Soman et al. [8] shows that 30% replacement of sand with bottom ash has given a 28 day compressive strength of 38.43 kN/m2 (target mean strength is 38.25kN/m2).

Feasibility Study of Fly Ash as a Replacement for Fine ...

feasibility of using fly ash which is an industrial by product as a replacement of fine aggregate is studied. This paper presents the results of experimental investigation carried out to evaluate the strength performance of concrete by replacing natural sand by fly ash in various percentages when subjected to elevated temperature.

An Overview of Fly Ash and Bottom Ash Replacement in Self ...

The Utilization of Aluminum Waste as Sand Replacement in Concrete ... This paper reviews the fly ash and bottom ash replacement in SCC. Info: Periodical: Key Engineering ... "An Overview of Fly Ash and Bottom Ash Replacement in Self-Compaction Concrete", Key Engineering Materials, Vols. 594-595, pp. 465-470, 2014.

Parametric Study for Replacement of Sand by Fly Ash for ...

replacement of 15% sand with fly ash by weight increased the compressive strength by about 30%. They also reported good surface finish due to addition of fly ash as replacement of sand which also reduces the permeabil-ity and has an attractive dark colour.

Investigation of coal bottom ash and fly ash in concrete ...

Rafieizonooz et al [8] have substituted the fine aggregate with coal bottom ash and cement with fly ash. Proportions used in this study were 0%, 20%, 50%, 75% and of coal bottom ash and 20% ...

STUDY OF USAGE OF BOTTOM ASH AS PART REPLACEMENT …

Replacement of Sand with Bottom Ash Optimized mix proportion for three types of Bottom Ash collected and identified as BA – I, BA – II and BA – III were selected for the trials.

Effect of Natural Sand Replacement by Fly Ash and Bottom ...

Using 150mm by 300mm Cylinders, fly ash as a partially and fully replacement of sand and bottom ash as a partially and fully replacement of fine aggregate will be …

Suitability Of Pond Ash As Partial Replacement Of Fine ...

Suitability Of Pond Ash As Partial Replacement Of Fine Aggregate In PPC Concrete ... plants is pond ash however; rest 75% is fly ash. Pond ... "Effect of bottom ash as replacement of fine aggregate in concrete," Asian Journal of Civil Engineering (Building and Housing) vol. 8, No 1 ...

What are the materials for partial replacement of sand in ...

Replacement of sand in concrete 1. 【Washed Bottom ash】 It is the waste of coal fired thermal power plant and generally disposed in landfills.it can be used for replacing sand to the amount of 35% in a concrete mix.. 2. [Construction demolition waste (crushed and sieved)]

The Properties of Special Concrete Using Washed Bottom …

The Properties of Special Concrete Using Washed Bottom Ash (WBA) as Partial Sand Replacement Mohd Syahrul Hisyam bin Mohd Sani*1, Fadhluhartini bt Muftah 2, ... The Q – DEJ contain high fly ash and bottom ash while Lati contain low fly ash and high bottom ash. This BA has 9.76 pH concentrations.

Effect of coal bottom ash as partial replacement of sand ...

Effect of coal bottom ash as partial replacement of sand on properties of concrete ... crumb rubber, coal bottom ash and quarry dust as a replacement for sand ... Most of the collected fly ash and ...

Parametric Study for Replacement of Sand by Fly Ash for ...

The use of fly ash as replacement of sand is an economical solution for making green and denser concrete. The paper presents a concrete mix design procedure for partial replacement of sand with fly ash.

Vol. 2, Issue 5, May 2013 USE of FLYASH as PARTIAL ...

pond/bottom ash) were considered for experimentation. Keeping water cement ratio a constant of 0.8 adopting both the methods of mix design (by weight and volume), replacing sand by flyash partially.

Effect of coal bottom ash as partial replacement of sand ...

Yuksel and Genc (2007) observed that workability of concrete mixtures containing varying percentage from 10% to 40% of bottom ash as sand replacement, 35 kg/m 3 of fly ash, 350 kg/m 3 of cement and 167 l of mixing water, improved with reference to control concrete. With 50% bottom ash as sand replacement, the workability marginally …

Experimental Investigation Of Partial Replacement Of ...

Fly Ash And Sand With Bottom Ash And Glass Used In Concrete by 30, 40, and 50 % to produce Concrete. Reinforced Concrete (RC) is tested for Compression, split tension and flexural strengths.

Can flyash replace cement in concrete? - Quora

No! Fly ash is used to improve the quality and durability of concete. Fly ash improves concrete's workability, pumpability, cohesiveness, finish, ultimate strength, and durability as well as solves many problems experienced with concrete today–and all for less cost.

What's In Your Fly Ash and Bottom Ash? - Advancing …

Fly Ash and Bottom Ash Benefits Fly ash can easily combine with calcium hydroxide to form needed compounds in the cement process, providing a lower-cost substitute for clay, sand, limestone and gravel. Fly ash produces a strong, durable concrete that is resistant to harsh chemicals.

PROPERTIES OF LIGHTWEIGHT CONCRETE MANUFACTURED …

Fly ash (FA), furnace bottom ash (FBA) and Lytag (LG) were used in the current study to replace ordinary portland cement (OPC), natural sand (NS) and coarse aggregate (CA), respectively, and thereby to manufacture lightweight concrete

Replacement of Sand | Fly Ash | Concrete - Scribd

Bottom ash Replacement of fine aggregates with bottom ash can easily be equated to the strength development of normal concrete at various age. Olive oil waste (Husk) and Burned Husk (Ash) 25% replacement of olive husks a long with sand to ensure reasonable concrete behavior.

Study on Strength of Concrete using Fly Ash and Bottom Ash ...

In this investigation a study is carried on fly ash and bottom ash as cement and sand replacement materials in concrete. Study on Strength of Concrete using Fly Ash and Bottom Ash as a Partial ... mixes made with and without fly ash and bottom ash replacement was determined at 7 and 28 days. The test results are shown in Table 3.3 & Figure 3.3 ...

Fly ash - Wikipedia

Ash that falls to the bottom of the boiler is called bottom ash. ... But if fly ash is used as a filler to replace sand in concrete production, unbeneficiated fly ash with higher LOI can be also used. Especially important is the ongoing quality verification.

Geopolymer Concrete by using fly ash and GGBS as a ...

Geopolymer Concrete by using fly ash and GGBS as a Replacement of Cement N.Manoj kumar1, P.Hanitha2 1(P.G Scholar, Department of Civil Engineering, ... sand is used as a fine aggregate at places where natural sand is not available crushed stone is used as fine aggregates.

THE POTENTIAL OF BOTTOM ASH AS FINE AGGREGATE …

THE POTENTIAL OF BOTTOM ASH AS FINE AGGREGATE REPLACEMENT IN CONCRETE MOHD AZIIv1 BIN MUHAMMAD ... The replacement of bottom ash on the sand in the ... Two types of ash, fly ash of 80 percent and bottom ash of 20 percent are

Coal Bottom Ash/Boiler Slag - Material Description - User ...

When pulverized coal is burned in a dry, bottom boiler, about 80 percent of the unburned material or ash is entrained in the flue gas and is captured and recovered as fly ash. The remaining 20 percent of the ash is dry bottom ash, a dark gray, granular, porous, predominantly sand size minus 12.7mm (½ in) material that is collected in a water ...

The Effect of sieved Coal Bottom Ash as a Sand Substitute ...

Abstract. This paper presents the results of an experimental investigation on the effect of sieved coal bottom ash as a substitute for natural sand on the properties of concrete, when an extra 5%, 10%, 15%, 20%, 25% and 30% weight of cement was added.

CONCRETE Optimizing the Use of Fly Ash in Concrete

Optimizing the Use of Fly Ash in Concrete CONCRETE Introduction Fly ash is used as a supplementary cementitious material (SCM) in the ... For the purposes of this document the replacement levels shown in Table 1 will be used to represent low, moderate, high and ... the furnace and is termed bottom ash; this material is not generally

Investigation of coal bottom ash and fly ash in concrete ...

At 7 d and 28 d, all fly ash-bottom ash mixes showed the resistance of concrete incorporating coal bottom ash as partial or total tensile strength lower than C0 mix except FBC3, but as the age replacement of sand, Constr. Build.